STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Peel the overlay from the backing paper and start lining up the edge closest the the badge and grille. As you position this piece you can gently rest the reminder of the overlay on the light as it can easily be picked up and repositioned as you move along it. Work your way from left to right smoothing and adhering the vinyl as you go.
STEP 3: DETAILS
Watch below as our installer lifts areas of the overlay, applies heat and re-smoothes to ensure a seamless and neat finish. Next apply the outermost piece designed to cover the silver inside the headlight, at the edge closest to the car doors. Starting from top to bottom or side to side, gently place on the overlay on the headlight and smooth. Don't rush the process as this can cause creases, if you move slowly you can always lift the vinyl and smooth again.
STEP 4: FINISHING TOUCHES
Repeat above steps with the other headlight to complete the set. Contact us if you have made a mistake and we will happily provide a solution.