STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre. If you have ordered more than one Ford badge overlay you will need to cut around each of them to separate them prior to installing.
STEP 2: APPLICATION
Once the badges are separated from one another, peel the badge from the backing paper using the transfer tape. Position the badge overlay on the corresponding badge and gently tack in the middle, step back and assess. If you need to move it gently peel off and re adjust.
Once in the correct position, starting from the middle apply pressure with your finger and smooth out in a circular motion moving further away from the centre as you go. If a crease appears, attempt to lift that section of the vinyl and smooth out.
STEP 3: FINISHING TOUCHES
Gently peel back the transfer tape to reveal the finished Ford Badge Overlay. To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer. Repeat above steps with remaining badges.
Contact us if you have made a mistake and we will happily provide a solution.