STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre. You will start with applying the piece with the clear transfer tape over it. The second piece for around the outer edge of the light will be done after this.
STEP 2: APPLICATION
Peel a portion of the backing paper back first and start with lining up the top edge, you can lift and reposition a few times while holding onto the transfer tape. Once it is in the correct position at the top gradually work your way around the daytime running light, peeling back the backing paper as you go.
STEP 3: DETAILS
Once the whole overlay has been secured on the light through the transfer tape, gently peel back the transfer tape. If you rush this step you risk lifting or stretching the overlay. Once the transfer tape has been removed, use your finger to smooth down all the edges apply heat with a heat gun or hair dryer.
STEP 4: FINISHING TOUCHES
Peel the outer trim piece partially off the backing paper like done in the first step. Position on the top edge of the headlight and smooth from left to right. As you work your way around the light you will need to lift some areas and pull taut especially on the curves of the headlight. With all the backing paper removed gently use your finger tip to smooth the edges and wrap the remainder of the piece down the bottom edge of the headlight.
Contact us if you have made a mistake and we will happily provide a solution.