STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
This product can be applied wet or dry. If you proceed with wet install, spray the area and the adhesive side of the overlay with water before starting installation (as shown in the video). Peel the overlay from the paper backing.
Starting at the top edge, line it up on the tail light and place it in the desired spot. Using a squeegee or card with a microfibre cloth wrapped around it to apply pressure to the entire overlay, working from top to bottom or left to right.
STEP 4: FINISHING TOUCHES
To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer.
Contact us if you have made a mistake and we will happily provide a solution.