STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt, dust or coatings prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Peel the overlay from the backing and start by lining it up with one end of the splitter. Leave enough overhang to neatly do the end piece after you adhere the majority of the overlay (as shown in the video). Place the vinyl on the top side of the splitter applying sufficient pressure as you work your way across the splitter.
STEP 3: DETAILS
Pull taut while you guide it around the slight curve of the splitter. Use your finger to wrap the remaining edge to the underside of the car and then apply heat across the whole area to further aid the adhesive. For the edges, pull the vinyl downwards following the shape of the splitter.
STEP 3: FINISHING TOUCHES
Trim away any excess vinyl at the edges for a seamless finish. To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer. Contact us if you have made a mistake and we will happily provide a solution.