STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
Dry fit the overlay. Before peeling the backing, hold the overlay up to the Front Intake to get a feel for its placement and alignment. Identify key edges or contours you’ll use to line it up.
STEP 2: APPLICATION
Starting with the largest piece tack the longest edge down smoothing top to bottom as you move left to right. This is best shown in the video instructions. You will likely need to use heat to aid installation for this product.
Smooth with your finger tip on either side of the horizontal area, it can get tricky given the small space so take your time so lift and reposition as needed like shown in the video.
Once the full piece is applied, apply the small piece designed for the top side of the horizontal area. Line it up on the front side of the edge and let it fold onto the inside covering the red/grey on the topside.
STEP 3: FINISHING TOUCHES
Once fully applied, press along all the edges and curves to make sure it’s completely bonded. If needed, apply light heat from a hair dryer to help it conform (especially around curves).
Contact us if you have made a mistake and we will happily provide a solution.