STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
Dry fit the overlay. Before peeling the backing, hold the overlay up to the light bar to get a feel for its placement and alignment.
This can be installed wet or dry, however wet makes for much easier positioning and is recommended. Fill a spray bottle with water.
Step 2: APPLICATION
Generously mist the surface and the adhesive side with water. Peel the tint from its backing and position the overlay so the top edge follows the factory line of the DRL lens and the ends sit flush with each headlight.
Use the centre Hyundai emblem or radar unit (if fitted) as your midpoint reference, then slide left/right to equalise gaps. Squeegee from the centre out. Wrap a felt squeegee (or credit card in microfibre) and push fluid and air toward the edges in overlapping strokes.
STEP 3: FINISHING TOUCHES
Warm the tint lightly (≈ 40–50 °C) with a hair‑dryer/heat‑gun on low. Re‑squeegee all edges; this locks adhesive and helps evaporate residual moisture.
Run a fingertip along the top and bottom seams. If an edge lifts, re‑spray backside, re‑lay, warm, and press firmly.
Avoid washing the car or using high‑pressure water for at least 48 hrs. Contact us if you have made a mistake and we will happily provide a solution.