STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt, dust or coatings prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Peel the curved overlay from the backing and start by lining it up with one end of the splitter (as shown in the video). Positioning is very important for this product, you need to push the vinyl it into the recess to conceal the red. There may be some overhang but this should be trimmed away with a knife. Next apply the long straight piece to the middle section using the same method. Repeat the curved overlay for the other side.
STEP 4: FINISHING TOUCHES
Trim away any excess vinyl at the edges for a seamless finish. To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer. Contact us if you have made a mistake and we will happily provide a solution.