STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Carefully peel the vinyl overlay from its backing. Avoid touching the adhesive too much to keep it clean, you can only partially peel it off the backing if this helps (as shown in the video). Align the overlay to the edge of the area under the headlight and grill.
Next using your finger tips, gently guide the vinyl over the curve of the car using a left to right motion, smoothing as you make your way to the other end.
STEP 3: FINISHING TOUCHES
To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer. Contact us if you have made a mistake and we will happily provide a solution.