STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Peel the overlay from the backing paper, and gently position on the area of the tail light. We suggest lining up one side first. Smooth from left to right using a squeegee or your finger. If required you can lift part of the overlay and reposition.
STEP 3: FINISHING TOUCHES
Gently peel back the clear transfer tape from top to bottom to reveal the finished overlay. To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer. Repeat above steps with remaining badges.
Contact us if you have made a mistake and we will happily provide a solution.