STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Start with applying the thick U shaped surround piece to the chrome casing around the badge. Line it up with the centre of the badge and tack at the top as shown in the video. Gradually smooth it around the entire casing, using your finger tips. Using a heat gun, heat the edges down in towards the badge. You can trim away the excess using a knife or leave the small excess under the next layer of the badge depending on your skill level.
Next place the full oval onto the badge, which will be your star colour once the final layer is applied. Once this piece is smooth and adhered to the badge apply the second layer using the transfer tape to position it on the badge.
STEP 3: FINISHING TOUCHES
Go over the entire overlay with firm pressure to ensure full adhesion, and then gently peel back the transfer tape at a 90 degree angle to reveal the completed badge. Lightly heat the area with a heat gun or hair dryer to further aid the adhesive.
Contact us if you have made a mistake and we will happily provide a solution.