STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
This product can be applied wet or dry. If you proceed with wet install, spray the area and the adhesive side of the overlay before starting installation (as shown in the video). Peel the third brake light overlay from the paper backing. Starting at one edge apply pressure and smooth the overlay down along the third brake light.
STEP 3: DETAILS
If you need to re-adjust, gently lift and reposition. If the vinyl stretches during installation, lightly heat the overlay with a hair dryer or heat gun to help it conform back to shape.
STEP 4: FINISHING TOUCHES
Gently smooth any creases with your fingers and push the vinyl edges into the gap for a neat finish. To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer.
Contact us if you have made a mistake and we will happily provide a solution.