STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Peel the overlay from the backing paper. Gently place it on the light and start smoothing from the centre out.
STEP 3: DETAILS
Once it has adhered fully to the surface of the indicator, use your finger or squeegee to work your way around the edge tucking the vinyl into the groove as shown in the video.
STEP 4: FINISHING TOUCHES
To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer. Contact us if you have made a mistake and we will happily provide a solution.