STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Peel the overlay from the backing paper. Position the overlay on the badge using the application tape to help adjust. If you need to move it gently lift up and re adjust.
Once in the correct position, peel back the application tape at a 90 degree angle. Apply extra pressure over the vinyl.
STEP 3: FINISHING TOUCHES
To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer. Contact us if you have made a mistake and we will happily provide a solution