STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Using the transfer tape position the overlay on the badge. Apply pressure with your finger over the whole vinyl area. Gently peel back the transfer tape at a 90 degree angle. Repeat this process for any remaining badges.
STEP 3: FINISHING TOUCHES
To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer. Contact us if you have made a mistake and we will happily provide a solution.