STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
If you are installing the inlay and plan to have a plastic badge cover over your OEM badge you can install the inlay without removing the factory badge. If you plan to leave your OEM badge chrome or only apply a vinyl overlay to it we recommend removing your factory badge and then installing the pieces. This way they sit seamlessly under the badge once re-applied.
Peel each individual inlay piece from the backing one at a time and place in the corresponding spot on the vehicle. Apply adequate pressure to ensure it has adhered sufficiently.
STEP 3: FINISHING TOUCHES
Post‑heat the entire emblem lightly (40–50 °C) and apply firm pressure around every edge, especially the narrow legs of the “W” and arc ends—to activate the adhesive.
Contact us if you have made a mistake and we will happily provide a solution.