STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Peel the overlay from the backing paper, and gently position on the area of the tail light. Smooth from left to right using a squeegee or your finger. If required you can lift part of the overlay and reposition.
STEP 3: FINISHING TOUCHES
To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer. Repeat above steps with remaining badges.
Contact us if you have made a mistake and we will happily provide a solution.