STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Start by peeling the individual "inlay" pieces from the backing paper. Apply these one by one, as shown in the video. Once all the inner pieces are installed, apply the logo that sits over the chrome using the transfer tape to position on the badge.
STEP 4: FINISHING TOUCHES
Gently peel back the transfer tape to reveal the finished logo. The angled edges of the badge will remain chrome as the overlay sits on the flat side only.
Contact us if you have made a mistake and we will happily provide a solution.