STEP 1: PREP
Clean the area with warm soapy water or an alcohol spray/wipe to remove any dirt and dust prior to installing. Dry the area completely with a microfibre.
STEP 2: APPLICATION
Peel the overlay from the backing paper and start with lining up the outermost edge. Once the top section is secured on the light, start to gently peel back the clear transfer tape. If you rush this step you risk lifting or stretching the overlay.
Smooth the along the whole top edge with your finger working your way to the other end of the headlight/overlay.
STEP 3: DETAILS
Next smooth the lower edge Guide the vinyl downwards smoothing gently over the curve of the headlight.
STEP 4: FINISHING TOUCHES
To further assist the vinyl in adhering you can lightly apply heat with a heat gun or hair dryer.
Contact us if you have made a mistake and we will happily provide a solution.