- Crafted from premium automotive-grade vinyl for durability and a perfect finish
- Precision laser-cut to ensure an exact fit every time
- Proudly Australian made and designed in-house for local quality you can trust
- Pre-cut PPF templates will end 2-3 mm from the edge of the panel as PPF is not able to end on a round/edge.
- If Smoke PPF is chosen, it will also end 2-3mm short of the end of the headlight.
What is the warranty on the film?
What are the benefits of the film?
My order arrived damaged/faulty?
What if I ruin part of my PPF product/kit?
Can I return the PPF product?*
How hard is PPF to install?
Video Instructions
- Wash the vehicle thoroughly to remove dirt and debris.
- Decontaminate the surface with a clay bar or clay mitt.
- Dry the area completely using clean microfibre towels.
- Wipe down the panel with isopropyl alcohol to remove any remaining oils or residues.
- Ensure workspace is clean, well-lit, and free of dust or wind.
- Slip Solution: Fill a spray bottle with water and add a few drops of baby shampoo or slip agent. This helps position the film.
- Tack Solution: In a separate bottle, mix water with 20–30% isopropyl alcohol. This helps the film stick when you're ready to secure it.
- Spray both the panel and your hands with slip solution to prevent fingerprints and premature sticking.
- Peel the film from the backing and generously spray the adhesive side with slip solution.
- Place the film on the panel, sliding it into position as needed.
- Once aligned, spray tack solution under one edge or corner to lock it in place.
- Begin squeegeeing from the tack point outward, using overlapping strokes to push out water and air.
- Use slip solution on top of the film to reduce friction on the squeegee.
- Double-check for bubbles or moisture under the film — push these out carefully.
- Use heat to set the film edges and ensure proper adhesion.
- Allow the film to cure for 24–48 hours before washing or exposing to harsh elements.